Connecting The Product; Setting Up The Product - nedis WIFILS51CRGB Manual Del Usuario

7. Set your location, choose the rooms you want to connect
with and tap Done.

Connecting the product

1. Plug the power cable A
2. Plug the controller plug A
3. Plug A
1 into a power outlet.
4. Check if A
8
If A
does not blink, press and hold the power button
8
4
A on A
4
5. Tap + in the top right corner.
6. Under Search Device, select the product from the list of
available devices.
7. Check if A
8
8. Enter the password of the Wi-Fi network to which your
phone is connected and tap Confirm.
9. Rename the product after it has been found and added.

Setting up the product

1. Unplug A
1
2. Clean the surface from dust and grease.
The surface must be smooth. Do not place the product
4
on knitted/wool fabrics, dust wall, rough plastic surface or
frosted glass.
3. Remove part of the 3M tape from the back of A
4. Place the start of A
5. Make sure the power outlet is within reach.
6. Unroll A
.
8
7. Remove the 3M tape and press A
position.
8. Firmly press A
- Do not use hard objects to press A
damage.
-
Do not bend A
If desired, cut A
4
- Cutting A
8
product.
9. Plug A
1 into a power outlet.
Controlling the product
1. Press A
to switch the product on or off.
4
2. Press and hold A
the product.
3. Press the mode button A
4. Press the brightness buttons A
5. Press the colour buttons A
1
is blinking. If so, confirm in the app.
2 for 5 seconds.
is blinking. If so, confirm in the app.
from the power outlet.
8 in the desired position.
8 down with your hand.
8 at sharp angles to prevent damage.
8 to size on the indicated cut lines.
removes the waterproof qualities of the
on A
4 2
5
into the controller A
into the LED strip A
6
into the desired
8
down to prevent
8
for 5 seconds to factory reset
to change modes.
to adjust the brightness.
3
e to adjust the colour.
6
.
2
8 .
.
8