Tabla de contenido
Publicidad
Signals
When a key is presse, please wait for the signal to register with the sensor module before attempting
to set another parameter.
Position of remote control:
Depending on the sensor tap design, make sure the remote control is pointing at the sensor receiver
in order to register signals/communications. If communication between sensor module and remote is
erratic, try moving the remote control at a slight angle for better connection.
Waterproof
This device is not water/splash proof. Avoid getting too close to the spout of sensor tap, as this will
trigger the sensor eye and could get the device wet.
TIP:
If you need to get closer to the spout in order to set parameters (i.e. sensor taps with integrated spout
sensors), try switching o water supplies for' 'dry setting' .
Battery Installation
Push down slightly on the area circled
and slide downwards to remove back cover
Insert 2x AAA batteries
22
Publicidad
Tabla de contenido
