Mopar RAM AIRFLOW Manual Del Usuario página 4

-----------------------------
PROCEDURAL STEPS
NOTE: When disconnecting and isolating the negative
battery cable for the 12 volt system, this will also power
down the 48 volt battery system. No extra steps will be
needed for a power down of the 48 volt system.
1. Disconnect the Intelligent Battery Sensor {IBS) wire
harness connector (A).
NOTE: Failure to disconnect the IBS wire harness can
lead to damage of the IBS wire harness
connector.
2. Remove the ground terminal M8 nut (8) with a 8mm
wrench, and remove the negative battery cable eyelet
from the IBS.
Save hardware for reinstallation.
3. Remove the (12) push pins with the trim tool and
remove the beauty cover.
Save push pins for installation of new beauty cover.
Discard old beauty cover.
4. Loosen clean air duct clamp at the throttle body.
July 19, 2019
www.mopar.com
/
8mmWrench
J
K6864061AA