BGS technic 9273 Manual De Instrucciones página 4

COMPONENTS
No. Designation
1 Stop ring
2 Fixing screw
3 Setting scale
4 Hexagon drive
5 Thread M14x1.25
6
Stylus
7 Knurled sleeve
USE
1. Disassemble the spark plug, insert the tool in the spark plug
thread and fix.
2. Turn knurled sleeve (7) until the -0- marking is positioned
opposite the marking line on the bottom part of the tool.
3. Loosen fixing screw.
4. Turn the crankshaft in the "normal" direction of
rotation until the piston is positioned TDC. The TDC
position is reached once stylus (6) protrudes the
furthest out of the tool.
5. Tighten the fixing screw.
6. Turn the crankshaft a half a rotation against the
"normal" direction of rotation.
7. Turn the knurled sleeve (7) to the right by the
necessary value in mm (pre-ignition in mm).
8. Carefully turn the crankshaft in the "normal" direction of
rotation until until the piston crown rests against stylus
(6).
9. Now the piston is located in front of the TDC by the set
value in mm.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Holds the stylus in the basic device
Fixes the stylus in the basic device
Enables a setting accurate to the millimetre
Tightening the tool in the spark plug thread
Inserting the tool in the spark plug thread
Stop for the piston crown
Enables a setting accurate to the millimetre
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Function
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed