Tool Operation; Environmental Protection - BGS technic 409 Instruction Manual

COMPONENTS
1 Thread for nose pieces
2 Nose pieces
3 Nose piece wrench
4 Bottle
5 Handle
CHANGE THE RIVETER NOSE PIECES
1. Choose the correct nose piece size, it must match the rivet
size.
2. Change the nose piece using the supplied mouthpiece key.
3. To loosen, turn the nose piece counterclockwise and vice
versa.

TOOL OPERATION

1. To install a rivet, open the handles outward as far as they will go.
2. Put the desired size rivet in the end that corresponds with the installed nose piece.
3. With the handles spread wide, push the rivet into the pre-drilled hole and put a slight amount of
pressure on the rivet and work piece. Then squeeze the handles together until the rivet head
pops loose from the mandrel.
4. Sometimes one squeeze will not be sufficient to separate the rivet from the mandrel as longer
and larger diameter rivets may require more than one squeeze.
5. Re-spread the rivet handles and slide the nose piece against the rivet button and squeeze
once again till the rivet pops loose from the mandrel.
CAUTION
When breaking the riveter loose from the rivet, please assume a firm stance as you may lose your
balance, which could result in serious injury.

ENVIRONMENTAL PROTECTION

Dispose of this product at the end of its working life environmentally. Recycle unwanted
materials instead of disposing of them as waste. All tools, accessories and packaging should
be sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed