Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL OPERATING SAFTY NOTES
Please note the following safety notes and instructions for use in this manual to avoid malfunctions,
damage or physical injure:
• This tool is not intended for use by individuals (including children) with limited physical, sensorial
or mental abilities or deficiencies in experience and/or persons unfamiliar with the torque wrench
unless they are supervised by a person responsible for their safety or receive from this
instruction in how the torque wrench is to be used.
• Do not allow children to play with this tool or its packaging.
• When using torque tools it is possible that fasteners may break or slip. Always stand with both
feet on the floor and avoid applying torque in awkward positions.
• Note! The torque wrench function is only available for right direction at longest cross bar
leverage mode shown on below.
• Set torque to lowest level (70 Nm) if you are using the torque wrench as a general-purpose
driving wrench at left direction for loosening nuts.
• Warning! Do not use any improvised extension rods or universal ball joints, as these could result
in incorrect torque settings.
• Warning! Do not step down on the scale window and the handle of the cross shaft, it may be
break and risk of injury.
• The drive part of the tool and any accessories should always be in line with the fastener.
Misalignment and uncontrolled movement will affect accuracy.
• Do not exert any pressure on the torque wrench beyond the set torque. This might lead to
damage to the wrench or the nut.
• Do not turn adjustment below lowest torque setting.
• The torque wrench was checked and calibrated with an accuracy of +/- 4% at the factory.
Recommend that your torque tool be calibrated after about 5,000 cycles or after 12 months by
educated people.
• Ensure that the torque is set at the lowest level (70 Nm) if you are not using or are storing the
torque wrench.
WORK AS A CROSS WRENCH FOR LOOSENING NUT
Leverage power mode
For a power mode as cross wrench which loosens nuts up to 340 Nm
(max. of 1/2" drive sockets).
Warning! DO NOT step down on the scale of window and handle of
cross shaft (2), it may break and risk of injury.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
Tabla de contenido
