Troubleshooting - Jocel JF109 Instrucciones De Uso

Error codes
If there is an error, the LED will flash a several times as indicated in the table below.
Failure of temperature control knob
Failure of defrost temperature sensor
Door doesn't colse well

Troubleshooting

Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician
of competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
The food is too warm
Appliance cools
too much
Cause
Possible cause
Temperature regulation knob is set
at number "0".
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
Temperature is
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the wall
or other objects.
Interior lighting LED flashes
Set the knob at other number to
switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains
corrected by an electrician.
not properly Please look in the initial Temperature
Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please
location section.
Turn the temperature regulation knob
to a warmer setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
1x
2x
3x
Solution
malfunctions are
look in the installation
to be
61