Appearance Of The Heart Arrhythmia Indicator For Early Detection; Data Memory; Viewing The Stored Values; Memory Full - Microlife BP W100 Manual Del Usuario

4. Appearance of the Heart Arrhythmia Indicator for
early Detection
This symbol AM indicates that certain pulse irregularities were
detected during the measurement. In this case, the result may
deviate from your normal blood pressure – repeat the measurement.
In most cases, this is no cause for concern. However, if the symbol
appears on a regular basis (e.g. several times a week with measure-
ments taken daily) we advise you to tell your doctor. Please show
your doctor the following explanation:
Information for the doctor on frequent appearance of the
Arrhythmia indicator
This instrument is an oscillometric blood pressure monitor that also
analyses pulse frequency during measurement. The instrument is
clinically tested.
The arrhythmia symbol is displayed after the measurement, if pulse
irregularities occur during measurement. If the symbol appears
more frequently (e.g. several times per week on measurements
performed daily) we recommend the patient to seek medical
advice.
The instrument does not replace a cardiac examination, but serves
to detect pulse irregularities at an early stage.
6
All manuals and user guides at all-guides.com

5. Data Memory

At the end of a measurement, this instrument automatically stores
each result, including date and time.

Viewing the stored values

Press the M-button 5 briefly, when the instrument is switched off.
The display first shows «M» AL and then a value, e.g. «M 17». This
means that there are 17 values in the memory. The instrument then
switches to the last stored result.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to toggle between one stored
value and another.

Memory full

Clear all values

If you are sure that you want to permanently remove all stored
values, hold down the M-button (the instrument must have been
switched off beforehand) until «CL» appears and then release the
When the memory has stored 200 results, the display shows
«Full M» after a measurement. From this point onwards, a
new measured value is stored by overwriting the oldest
value.