Heylo HL 400 Manual Del Usuario página 18

Press the "Sleep" button to manually operate the unit at the quietest
level. The automatic mode is then terminated. All lights and displays will
switch off and the fan will run at the lowest speed.
NOTE: The second function of the sleep button is to reset the filter
replacement indicator. When it is on, press the button for 3-5 seconds
and the filter indicator is reset.
NOTE: the filter indicator is only active during operation. In stand-by
mode, the light indicates the WIFI status.
When the unit is switched on, you can use the "Timer" button to let the
unit run automatically for a certain time. The period can be selected from
30 minutes to 12 hours. You press the button repeatedly until the
desired time appears in the display. 5 seconds after the last press, the
unit switches back to the air quality display. (PM2.5 value). To switch the
timer function off again, press the button for 5 seconds. If you only press
briefly, you can read the remaining timer time.
Press
"Child Lock" button for 5 seconds to cancel the function
NOTE: To display the filter run time, press and hold the "Child Lock"
(before entering an operating mode) to see that the filter has been used
between 0- 1500 hours. After displaying for 5 seconds, it will
automatically exit the display.
When the product is switched on, pressing the "AUTO" button activates
negative ion generator and the UV lamp and the working level is set
depending on the sensor data. (The symbol lights up while the product
operating in
changes the blower speed while the
automatically terminated.
Fan stage
Light sensor:
In automatic mode, the product is put into sleep mode when the ambient
Fan stage
light falls below the value <5×. It exits the sleep mode again, after the
ambient light exceeds <5× for 3 minutes and then returns automatic mode.
WIFI For the operation of the WIFI function,
please refer to the WIFI quick start guide
included with the device
This product comes with a remote control
powered by 3V lithium cells. (Please
remove the cells when not using the
remote control for a long period of time).
The controls on the user interface on the
unit and on the remote control are directly
similar: all functions and operating modes
are basically identical.
the "Child Lock" button to activate the child
automatic mode and
PM2.5 value
1 less than 120
2 121-250
3 251-500
PM2.5 value
18
lock.
disappears otherwise). If the user
automatic mode is active, this mode is
Fan speed Display colour
430 green
600 orange
900
Fan speed Display colour
Press and hold the
the t
h
e
i
s
red
CURRENT SUPPLY
ON / OFF
EN