Maintenance / Fault Finding - Heylo HL 400 Manual Del Usuario

Ocultar thumbs Ver también para HL 400:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 49

11. Maintenance / fault finding

Warning: Danger of electric shock
The device must be disconnected from the power supply system before any maintenance work is
carried out on it. Electrical components must not be cleaned with a water hose or pressure washer, as
water could penetrate the electrical component and cause an electric shock.
When dismantling components, please turn the screws by hand to avoid damage to the
threads!
Fault detection and elimination
Problem
The unit does not respond
to switch-on
Air is polluted but the
display shows clean
(green)
The air quality display is
still very poor (red), even
though the product has
been switched on for a
long time.
If a strange noise
(knocking, chirping)
comes out of the device
If the product smells
strange
If the product does not
noticeably improve air
quality even after a long
period of operation
When the product is
switched on and shortly
after it is automatically put
into sleep mode
Possible reason
No power to the
device
Device does not stand
on a plain surface
Front cover is not
closed properly
Child lock is active
Device position is
unfavourable
Air sensor is dirty
Ionizer i s dusty
Filter is saturated
Filter not removed
from protective
packaging
Filter not inserted
correctly
Wrong operating mode
23
Solution
1. Make sure that the power plug is fully
inserted into the power outlet, then press
the power button to turn on the unit
2. Make sure that the front cover is inserted
correctly.
3. Make sure that the product is properly
installed on a plain surface.
4. When the display shows the child-proof
lock, press the "Child-Lock" button for 5
seconds to deactivate the lock and use the
device.
Position the unit differently so that the air in
the room can be better absorbed.
Clean the particle sensor with a cotton
bud as described in "cleaning and filter
change".
Clean the ionizer head with a brush as
described in section "cleaning and filter
change".
1. Clean the air inlet opening and internal
filter (pre-filter, integrated filter).
2 If you have not replaced the filter for a
long time, buy a new filter and replace
it.
1. Make sure that the packaging of the filter
(plastic bag) inside the product has been
properly removed
2. Make sure that the order of the filter
combination is correct
Please deactivate the sleep mode (night
mode).
EN

Publicidad

Tabla de contenido
loading

Productos relacionados para Heylo HL 400

Tabla de contenido