Dell PowerEdge 600SC Manual Del Usuario página 4

1W371bk2.book Page 2 Tuesday, December 17, 2002 1:02 PM
4
F i g u r e 1 - 1 .
thermal grease tab –
remove before installing
heat sink
cooling fan cable
cable connector
1-2
Microprocessor Upgrade Installation Guide
All manuals and user guides at all-guides.com
Remove the heat sink from the existing microprocessor (see Figure 1-1):
Disconnect the cooling fan cable from the fan connector on the system board.
a
Press down on the heat-sink securing clips to release the clips from the retaining
b
tabs on the ZIF socket.
Swing the securing clips to the fully open position.
c
Lift the heat sink away from the microprocessor.
d
R e m o v i n g a n d R e p l a c i n g t h e M i c r o p r o c e s s o r H e a t S i n k
securing clips (2)
cooling fan
heat sink
microprocessor