Troubleshooting - SPIT Spitfire P370 Manual De Instrucciones

EFFECTS
Malfunctioning of
the charge feed or
percussion device
Barrel jammed at the
back
Lack of power or
fluctuation in power
Too much force needed
to rest the tool on the
support
Impossible to close the
magazine's cover
Jamming of the inertia
block
Poor stud feed
18
Notice 010_GB.indd

Troubleshooting

CAUSES
- Insufficient force on the tool
when resting it on the support
- The charger disc has not turned
- Munition carrier sleeve not sliding
properly
- Malfunctioning of the charger
disc
- No more studs in the magazine
- Barrel dirty
- Tool too hot
- Moving assembly (barrel) dirty)
- Tool too hot
- Deterioration of the inertia block
- Inertia block very eroded
- Deterioration of the spring
- Deterioration of the insulation
ring
- Barrel dirty
- Presence of foreign matter
- More than 10 studs in the
magazine
- Stud guide not sliding properly
- Strip residues stuck
- Presence of residues in the
magazine
- Stud guide not sliding properly
P370 BACK PART
Only your SPIT agent or his representative is
authorized to disassemble this assembly.
18
REMEDIES
- Hold the tool resting on the support
- Check the condition of the small bar
- Disassemble, clean
- Check it
- See magazine pin
- Disassemble, clean
- Allow to cool
- Disassemble, clean
- Allow to cool
- Change it
- Change it
- Change it
- Change it
- Clean, oil and reassemble
- Clean, oil and reassemble
- Remove the studs
- Contact SPIT's after-sales service
department
- Clean
- Clean
- Contact SPIT's after-sales service
department
26/02/04, 7:52