Power Issues; External Display Issues - Toshiba Express Port Replicator II Manual Del Usuario

Power issues

Problem
Docked computer will not turn on
(Your computer' s AC power light
does not turn on)
Docked computer enters Resume
mode and shuts down
Docked computer shuts down and
its AC power light is flashing

External display issues

Refer also to your computer and monitor documentation.
Problem
External display does not turn on
Cannot display information to a
DVD-D and RGB Monitor at the
same time
Display error
Solution(s)
Check the connections. Make sure the power cord is firmly connected
to the port replicator and a live electrical power outlet.
Check the condition of the power cord and plug prongs. If the cord is
frayed or damaged or the plug prongs are bent, replace the cord. If the
plug prongs are soiled, wipe them with a clean cloth.
Disconnect and reconnect the AC adaptor and try again to turn on the
computer.
If the port replicator still does not power the computer, contact Toshiba
support. For contact information, please see
assistance" on page 34.
If the computer' s internal temperature becomes too high, the computer
will automatically enter Resume mode and shut down. Leave the
computer off until its interior reaches room temperature.
If the computer has reached room temperature and still does not start,
or if it starts but shuts down quickly, contact Toshiba support. For
contact information, please see
page 34.
Indicates a problem with the heat dispersal system of the computer.
Please contact Toshiba support. For contact information, please see
you need further assistance" on page
Solution(s)
Press hotkeys Fn + F5 to change the display setting. Choose a setting
that displays information to an external monitor. Refer to your computer
user's manual for more information on display settings.
Make sure that the monitor' s power switch is on. Confirm that the
monitor' s power cable is plugged into a live electrical power outlet.
Try adjusting the contrast and brightness controls on the monitor.
Check that the cables connecting the monitors are firmly attached on
both ends.
Some computer models do not support output to DVI and RGB
monitors simultaneously. Check the documentation for your computer
model.
Check that the cable connecting the monitor to the port replicator is
firmly attached.
If the problem persists, contact Toshiba support. For contact
information, please see "If you need further assistance" on page
Troubleshooting
Power issues
"If you need further
"If you need further assistance" on
34.
31
"If
34.