Input Output And Control Section - dB Technologies DVA K5 Manual Del Usuario

INPUT OUTPUT AND CONTROL SECTION

1. BALANCED AUDIO INPUT
Audio input for a cable equipped with a
balanced XLR connector.
2. LINK AUDIO OUTPUT
Balanced XLR output, allowing to send the input audio signal to
another amplified speaker.
3. AUDIO INPUT SENSITIVITY
It allows to vary the input sensitivity. Before turning on the unit,
make sure that the Audio Input Sensitivity is turned to 0 dB.
4. DSP CONTROL ROTARY ENCODERS FOR IN LINE-ARRAY SETTING
The "SPEAKER COUPLING" rotary encoder and the "HIGH FREQUENCY
COMPENSATION" rotary encoder allow to optimise the sound
behaviour of the K5 modules configured in a line-array. Also refer to
paragraph "IN LINE-ARRAY CONFIGURATION AND OPTIMISATION".
5. LEDs (Limiter, Signal, Mute/Prot, Ready)
During normal speaker operation with audio input signal, the Ready LED is steadily on, the Signal LED blinks
indicating the signal presence.
6. "SERVICE DATA" USB PORT
The type B mini-USB B port allows to update the product firmware. For further information, please refer to
the Web site (see DOWNLOADS section and )
LED TYPE SPEAKER
SWITCH-ON
LIMITER OFF
OFF
SIGNAL
MUTE/ ON FOR A
PROT FEW SECONDS
READY OFF
DVA K5
NORMAL GENERIC
OPERATION WARNING
TURNED OFF, TEMPORARY
TURNS ON BLINKING
ONLY IN THE
EVENT OF
INTERVENTION
BLINKING WITH NORMAL INPUT
SIGNAL AUDIO INDICA-
TION
OFF TEMPORARY
BLINKING
STEADILY ON STEADILY ON
LEDs table
English
STOP DUE TO
SPEAKER MALFUNCTION
ONGOING CYCLIC BLINKING
OFF
STEADILY ON
OFF
Code 420120232 REV.1.1
31