Power Supply Connection And Linking - dB Technologies DVA K5 Manual Del Usuario

English

POWER SUPPLY CONNECTION AND LINKING

POWER SUPPLY
• Connect the first module power supply to AUTO-RANGE MAINS INPUT (7). For this
purpose, use a cable equipped with a powerCON connector (not included in the supply).
• Extend the power supply from the first to the second module, by connecting the MAINS
LINK OUTPUT (8) to the AUTO-RANGE MAINS INPUT (7), as shown in the figure.
• Repeat the operation between the second and the third module, and so on, until all
line-array modules are connected (check the maximum number of power supply links in
Technical Specifications).
DVA K5
36
FIRST DVA K5 MODULE
!
ATTENTION
• The amplifier nameplate of a DVA K5 module specifies the nominal
maximum and total current (and power) value of a multiple module
system with extension connections.
• The cables must be properly sized and design, installation and system
testing should exclusively be performed by qualified personnel. AEB
Industriale accepts no responsibility in case of use of cables which
are unsuitable, non-certified, non-compatible with the correct system
sizing and the regulations in force in the country of use.
SECOND DVA K5 MODULE
LINK
Code 420120232 REV.1.1