Simplified Eu Declaration Of Conformity - MELICONI HP DIGITAL PRO Manual Del Usuario

If the headphones do not produce any sound or if the audio signal is disturbed or is presumed to come from other unde-
sirable sources, carry out the following steps:
1. Check that all the connections are correct and that the device is operating as described in the handbook.
2. Make sure the connectors of the audio cable used for connection are inserted correctly (and sufficiently deeply) into
the pertinent sockets.
3. If the audio feed has been connected using a digital optical cable (Toslink), move the "M" selector – on the side of the
charging dock – to "Optical", and check that the audio output of your appliance (e.g. TV or decoder) is set to "PCM"
or "LPCM". To do this correctly, consult the instruction manual of your TV or decoder.
4. If the audio feed has been connected using a traditional aux audio cable (3.5 mm jack), try turning up the volume of
the audio source and make sure the "M" selector is at "RCA/3.5 mm".
5. Switch off the headphones (receiver) using button "C", move closer to the charging dock (transmitter), switch it back
on and check that the green "I" (POWER/CHARGE) LED light comes on.
6. After switching on with push-button A, it may take a few seconds before the sound is heard. This is normal.
If you have any queries regarding HP DIGITAL PRO:
• read this instruction manual carefully, as it will help you solve most problems.
• visit our website www.meliconi.com
For any questions/problems, you can write an email to: telecomandi@meliconi.com
The manufacturer, Meliconi S.p.A., declares that the type of radio equipment marketed as HP Digital Pro Headset is
compliant with Directive 2014/53/EU (RED).
The full text of the EU Declaration of Conformity is available at the following web address:
http://www.meliconi.com/doc/hpdigitalpro
16
Troubleshooting
Help line

Simplified EU Declaration of Conformity