Using The Underwater Video Light (Optional); Water Leakage; After Using - Sony MPK-DVF7 Manual De Instrucciones

Recording (continued)

Using the underwater video light (optional)

In deep water or under rocks where direct
sunlight does not reach, recording with
underwater video lights is recommended.
You can attach these video lights to the video
light shoes on the upper part of both grips.

Water leakage

The marine pack is designed to be
waterproof, however if water happens to leak
in, the LEAK lamp (yellow) flashes.
In such a case, remove the marine pack from
the water as soon as possible, keeping it
horizontal. Be sure to surface following the
safety rules for diving.
Dry the marine pack with a soft cloth and
then open it.
To switch off the lamp, disconnect the remote control cable.
Check the cause of the leak.
If the camcorder is wet, take it to the nearest Sony dealer immediately.
We recommend you purchase property damage insurance for underwater materials in case of
emergency.

After using

• After recording in the sea, submerge the marine pack in tap water or fresh water for about 30-60
minutes before undoing the latches to completely remove any salt from the marine pack unit,
filter, and wide-conversion lens.
• When your camcorder has been used near or in the sea for a long time, we recommend that it be
checked by the nearest Sony dealer.
18
-GB
Underwater video lights such as the Sony
HVL-ML20M (optional)
Attachable to the video light shoes
on both sides
LEAK lamp (yellow)