Final Check - Sony MPK-DVF7 Manual De Instrucciones

Note on the O-ring (continued)
5
Apply a coating of grease to the O-ring.
• Apply a small drop of grease onto the O-ring and evenly coat the entire surface of the O-ring
• Do not use paper or cloth as fibre may stick to the O-ring.
• Make sure that a thin coating of grease is applied to the surface of the O-ring at all times.
• After you have applied a small drop of grease onto the O-ring, set the O-ring immediately.
6
Place the O-ring in the groove on the marine pack.
Place the O-ring evenly in its groove paying attention to the following points:
– Is there any dirt on the O-ring?
– Is the O-ring twisted?
– Do not pull the O-ring.
– Is the O-ring protruding?

Final check

After you have fitted in the O-ring, check it again for the following:
– Is the O-ring twisted?
– Is there any dirt on the O-ring?
– Is the O-ring protruding?
– Are there any cracking or distortion on the O-ring?
How to check for water leaks
After you have replaced the O-ring, close the marine pack before you insert the equipment you are
using. Immerse the marine pack for about three minutes in water to a depth of about 15 cm, and
check for water leaks.
PCAUTION
When you have taken photos on a sandy sea bottom or have placed the camera on the sand, remove
the O-ring and check for water leaks.
Be sure to take a spare O-ring with you.
This facilitates replacement even if O-ring trouble occurs where you
are recording.
24
-GB
with your finger.
Grease protects the O-ring, and prevents wear.
Do not leave the greased O-ring on a desk or other surfaces.
Bad example Good example