Economy Operation - Fujitsu Airstage UTY-RNK Serie Manual De Funcionamiento

OPERATION
NOTES
(1) • Always use the "
Attempting to move the airflow direction louvre
manually could result in improper operation; in this case,
stop operation and restart.
The louvre should begin to operate properly again.
• During cooling operation, do not set the vertical airflow
direction louvre in the downward position for an ex-
tended period. Water vapor may condense near the out-
let port and drops of water may drip from the air condi-
tioner.
(2) • The range of swing is relative to the currently set airflow
direction.
• The SWING operation may stop temporarily when the
air conditioner's fan is not operating, or when operating
at very low speeds.
(3) The swing operation is not available depending on the
model. Please refer to the operating manual for the in-
door unit.

ECONOMY OPERATION

To set the economy operation
G Economy setting
NOTES
About ECONOMY Operation
Economy operation can be set by remote controller.
The temperature setting is offset automatically over a certain period of time.
Based on temperature set in remote control unit, temperature of indoor unit varies little by little. However in this case,
temperature indication of remote control unit does not vary as it continues to indicate the temperature when ECONOMY
Operation was set.
Save temperature
Cooling set temperature
Heating set temperature
Save temperature
En-5
" button or the " " button.
°C
Cooling
2
Operation
1
0
0
1
Heating
2
Operation
3
4
<Vertical airflow swing operation>
Airflow direction Range of swing
1
2
3
4
<Horizontal airflow swing operation>
Airflow direction Range of swing
1
2
3
4
5
Press the "ECONOMY /
or stop the energy-saving air conditioner operation.
* Press the "START / STOP" button to set the air conditioner
in the operation mode.
Then, proceed with the following steps.
* The energy save air conditioner operation is not available
depending on the model.
0 30 60 90
ECONOMY operation
Start
1 to 4
(All range)
1 2
1 to 5
(All range)
THERMO SENSOR" button to start
Min.
1
2
3
4
4 5
3