Fitting The Door Lock - Dometic DM 100 Instrucciones De Montaje

All manuals and user guides at all-guides.com
DoorLock DM100, DP100
9

Fitting the door lock

9.1 Preparing the door leaf
I
NOTE
The door leaf must have a depth of at least 35
➤ Drill the holes and prepare the recesses for the door lock:
– DM100: fig. 2, page 4 and fig. 4, page 6.
– DP100: fig. 3, page 5 and fig. 4, page 6.
➤ Clean the recess for the lock and all drill holes by blowing out or vacuum-
ing any debris.
9.2 Fitting the door lock
➤ Guide the mortice lock data cable upwards through the recess.
➤ Affix the mortice lock (fig. 5 1., page 7) with two screws in the recess for
the lock.
➤ Fit the outer door handle with the corresponding spindle (fig. 5 2.,
page 7).
➤ DP 100 only: Connect the wide data cable to the outer door handle.
➤ Fit the inner door handle with the corresponding spindle and affix it with
three screws (fig. 5 3., page 7).
➤ Fit the profile cylinder (fig. 5 4., page 7).
➤ Fix the profile cylinder into place with the faceplate screw (fig. 5 5.,
page 7).
➤ Connect the required data cables to the control unit.
➤ Disconnect the cable for the power supply from the control unit (fig. 6 3.,
page 8).
➤ Insert four new AA batteries into the battery compartment (fig. 6 5.,
page 8).
➤ Connect the cable for the power supply to the control unit (fig. 6 6.,
page 8).
➤ Replace the battery compartment cover (fig. 6 7., page 8).
➤ Affix the battery compartment with the screw (fig. 6 8., page 8).
EN
Fitting the door lock
mm.
32