Set Up; Electrical Connections; Drain Connections - Hoshizaki HNC-120BE-L/R-BLH Manual De Instrucciones

15 cm

3. SET UP

Carry the showcase by holding its bottom.
When handling the carton or the unpacked unit, work in pairs to prevent injury.
Do not tilt the unit more than 45°.
Do not remove the tape(s) fixing the sliding glass doors until the showcase is installed.
Remove all the accessories inside before moving the unit.
1) Unpack the showcase, and remove all shipping carton, evaporator spacer, tapes and packing BEFORE operating the
unit. Be careful not to damage the exterior panels when handling the showcase.
2) Position the showcase in a selected site. Clean the interior with soap and water and rinse thoroughly.
3) Level the showcase in both the left-to-right and the front-to-rear directions.
4) The perimeter where the machine touches the counter should be sealed with silicone.

4. ELECTRICAL CONNECTIONS

This showcase must be plugged into the separated power receptacle which has enough capacity. The maximum allowable
voltage variation should not exceed ± 6 percent of the nameplate rating. See the nameplate.

5. DRAIN CONNECTIONS

* The hose may be connected to either right or left joint, whichever is convenient.
* The joint must be tilted as shown below to turn the hose connection downward.
* Keep more than 5 cm air gap between the vertical drain pipe end and the sink.
Joint
Open Space
Air Outlet
CAUTION
NOTICE
No good
Hose
Air Inlet
Good
Joint
5
ENGLISH
15 cm
Hose