Electric Start; Power Washer Start-Up - Generac A0001468710 Manual De Instrucciones

Electric Start

NOTE: The battery must be installed before
Electric Start operation. For initial battery
installation, see Assembly.
This power washer is equipped with both
electric start and recoil start capabilities. Avoid
prolonged cranking as it can damage the
engine. To extend the life of the starter, use
short starting cycles (no longer than 5
seconds). Wait 30 seconds between starting
cycles.
If the engine will not crank, the battery
temperature may be too hot. Remove battery
and allow to cool before attempting to start.

Power Washer Start-Up

WARNING
Vision Loss. Eye goggles are required to be
worn when using this machine. Failure to
wear eye goggles could result in permanent
vision loss.
WARNING
Personal injury. Risk of fluid injection. Do not aim
spray gun at people, animals, electrical devices, or
fragile items. Keep out of reach of children. Failure to
do so could cause death or serious injury.
WARNING
Fluid Injection. This machine produces
high-pressure fluid streams that can pierce
skin. Fluid injection could result in death or
serious injury.
WARNING
Risk of Fire. Hot surfaces could ignite
combustibles, resulting in fire. Fire could
result in death or serious injury.
WARNING
Hot Surfaces. When operating machine, do not
touch hot surfaces. Keep machine away from
combustibles during use. Hot surfaces could
result in severe burns or fire.
NOTE: DO NOT run power washer without a
sufficient water supply turned ON. Damage to
equipment resulting from failure to follow this
instruction will void warranty.
Electric Start
1. Connect a sufficient water supply.
2. See 3-2. Move fuel valve lever (A)
Figure
to ON.
Owner's Manual for Power Washer
B
A
Figure 3-2. Push START/STOP Button
3. For cold engine move choke lever (B) to
CLOSED.
NOTE: For warm engine, choke lever may
need to be in HALF-OPEN or OPEN position.
If engine does not start in those
move choke lever to CLOSED position and
attempt engine start.
4. See
(000101)
STOP (C) button for three seconds or until
button illuminates to energize starter
system.
5. Hold trigger on spray gun while pushing
the START/STOP button for one second to
start engine.
6. Release trigger on spray gun once engine
(000117c)
starts and move choke to OPEN.
NOTE: For electric start, the battery may
require charging for the power washer to start.
See Maintaining the
fails to start the engine, the power washer can
be started with the recoil start.
(000106b)
Recoil Start
1. Connect a sufficient water supply.
2. See
to ON.
(000110)
3. For cold engine move choke lever (B) to
CLOSED.
NOTE: For warm engine, choke lever may
need to be in HALF-OPEN or OPEN position.
If engine does not start in those
move choke lever to CLOSED position and
(000108)
attempt engine start.
4. Relieve spray gun pressure.
5. Place foot on unit to secure unit from
movement when pulling recoil.
6. See
while firmly grasping the recoil handle. Pull
slowly until resistance is felt. Then pull
rapidly to start engine.
3-2. Push and hold the START/
Figure
Battery. If the start button
Figure 3-2. Move fuel valve lever (A)
3-3. Hold trigger on spray gun
Figure
Operation
C
012435
positions,
positions,
9