Publicidad
Idiomas disponibles
Idiomas disponibles
17
This kit uses spring clamp style terminals.
Terminals use a steel spring to clamp the wire to provide
improved vibration resistance, reduced maintenance and faster
installation.
• Refer to wiring diagram,
step 18A, 18B, or 18C.
• Push screwdriver FIRMLY
into square hole.
• Insert wire into round hole.
• Use green terminal for braid
and ground wires.
Raychem-IM-H56344-JBM100A6-ML-1805
All manuals and user guides at all-guides.com
• Remove screwdriver.
• Repeat for all connections.
To connect wires, firmly insert a slotted screwdriver into the
square ole (
) to open t e spring.
1
2
screwdriver will lock into place, allowing you to remove your
and and insert t e ire into t e round ole (
screwdriver to clamp the wire. The wire is held securely against
the bus bar for low contact resistance over time without the need
to periodically retighten screws.
2
Wire
Wire hole
en full inserted t e
). Remove t e
1
2
1
Screwdriver slot
nVent.com | 7
Publicidad
