Attaching Or Removing Battery Pack - Panasonic EY74A2 Manual De Instrucciones

EN
WARNING
• Do not use other than the Panasonic
battery packs that are designed for use
with this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the use
of recycled or counterfeit battery pack.
• Do not dispose of the battery pack in a
fire, or expose it to excessive heat.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack in
the same container as nails or similar
metal objects.
• Do not charge the battery pack in a
high-temperature location, such as next
to a fire or in direct sunlight. Otherwise,
the battery may overheat, catch fire, or
explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
risk of fire.
• When the Battery Pack Has Deteriorat-
ed, Replace It with a New One. Contin-
ued use of a damaged battery pack
may result in heat generation, ignition
or battery rupture.
• To prevent leakage, overheating,
smoke generation, fire, and rupturing
from occurring, follow these instructions
when handling our rechargeable power
tools (tool main body/battery pack/
charger).
- Do not allow material cuttings or dust
to fall onto the battery pack.
- When storing, remove any material
cuttings and dust from the battery
pack, and place the battery pack
separately from metal objects
(screws, nails, etc.) when storing in
the tool case.
• Do not handle the rechargeable power
tools in the following way.
(There is a hazard of smoke genera-
tion, fire, and rupturing)
- Use or leave in places exposed to
rain or moisture
- Use submerging in water
EY74A2_EU.indb 10
All manuals and user guides at all-guides.com
III. ASSEMBLY
Attaching or Removing Bit
This tool is equipped with a keyless drill
chuck.
1. Attachment
2. Removal
Attaching or Removing Battery
Pack
1. To attach the battery pack: [Fig.4
2. To remove the battery pack: [Fig.4
IV. OPERATION
• Do not inhale any smoke emitted from
- 10 -
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
Insert the bit and turn the lock collar
clockwise (looking from the front) to
tighten firmly until it stops clicking.
[Fig.1]
Turn the lock collar counterclockwise
(looking from the front), then remove
the bit. [Fig.2]
NOTE:
If excessive play occurs in the chuck,
secure the drill in place and open the
chuck jaws by turning the lock collar
and tighten the screw (left-handed
screw) with a screwdriver by turning it
counterclockwise (viewed from the
front). [Fig.3]
Align the highlighted marker points and
attach battery pack.
Slide the battery pack until it locks into
position.
Push the button and slide the battery
pack forward.
WARNING!
the tool or battery pack as it may be
harmful.
]
]
2015/07/16 11:32:14