Dimplex Beethoven Manual Del Usuario página 5

Controls: See Fig. 2
Icon Function
A
Power
B
Heat
C
Temp
D
Flame Speed
E
Color Themes
F
Brightness
G
Flame
H
Timer
User Modes:
Mode Name /Discription
Change Celsius ( C) to
0
Fahrenheit ( F)
0
Disable / Enable Heat
Options
Description
Press to turn unit Off or On.
• Unit Off
Press to turn everything Off. Press again to turn unit On with previous settings.
• Unit On
Press to turn unit On with previous settings.
- If the flame effect was On, the flame will turn on and the previous heat setting will
be activated (On or Off). Display will show current heater temperature setting and
after 2 sec displays the room temperature.
- [remote only] If the flame effect was Off, the previous heat setting will be
activated (On or Off).
- [panel only] If the flame effect was Off, the flame will turn on and the previous
heat setting will be activated (On or Off)
• Heat On
Press to turn heat On (indicated by 1 short beep). Display will show current heater
temperature setting and after 2 sec displays room temperature. Use the Temp icon
to change the heater temperature setting.
• Heat Off
Press to turn heat Off (indicated by 1 short beep).
NOTE: After the heater is switched off, the fan will continue on for 60 seconds before turning
off.
Press multiple times to raise the heater temperature in 1
will show current temperature. Temperature range is 62
This feature is active whenever the heat is enabled.
Press multiple times to toggle through flame speeds (minimum, medium, maximum).
Display will show current speed number (F1, F2, F3 respectively).
Press multiple times to change the media and flame base colors. This feature is
active only when the flame effect is On. Display will show theme (t0, t1, t2, etc.)
XHD28L, XHD26L or XHD23L (Log Unit) themes:
• Theme t0 - no flame
• Theme t1 - Natural (flame base off)
• Theme t2 - Red Highlights (flame base red/orange)
• Theme t3 - Blue Highlights (flame base blue)
Press to change the flame and logs brightness. Display will show b3, b1, b2
respectively.
• High
• Low
• Medium
Press to turn the flame effect On. Press again to turn the flame effect Off.
Press multiple times to change the sleep timer by 0.5 hr from 0.5 hr to 8 hr before
turning off. Press again, the remaining time on the timer displays.
Action (Actions cannot be input by remote control)
Press both Temp Button (
heard and display flashes. (To revert back to Celsius repeat this action)
Hold both Heat Button (
heater has been disabled the display will read "--" and beep. To enable heat repeat this
action.
) and flame speed( ) on the unit and hold until beep is
) and Temp Button ( ), on the unit, for 2 seconds, when the
F (1 C) increments. Display
o o
-78 F (17 -26 C).
o o o o
EN