Publicidad
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1
Flush through the supply pipes.
2
Place the mixer including the sealing
washer in position on the basin / bidet.
3
Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4
Connect the supply pipes to the isolation
valves; cold right - hot left.
5
Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Technical Data
This mixer series-produced with
waterdimmer® (flow limiter).
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
4
English
7 l/min 0,3 MPa
17 l/min 0,3 MPa
max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
If the continuous water heater causes any
problems or there is not enough flow of water,
the waterdimmer® (6a) located behind the
aerator must be removed.
To adjust the hot water limiter on single lever
mixers, please see page 5.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 3
1
handle
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
seal
6
aerator cpl.
7
fixing set
8
connection hose 450 mm
9
pull rod
10
locking screw for handle
11
spout cpl.
12
sealing set
Special accessories
X special tool set 58085000
(order as an extra)
33092000
96338000
96468000
96461000
92730000
95008000
94010000
95049000
97372000
96657000
96059000
96521000
92646000
Publicidad
