Charging The Battery - sunjoe 4V-PS10-CT Manual De Operación

Charging the Battery

1. Push the push lock buttons on the battery to pull the
battery pack out from the battery compartment (Fig. 1).
Fig. 1
Battery pack
2. Depending on your Snow Joe
model, how to recharge your lithium-ion battery will
vary. You may either insert your 24-volt battery into the
24VCHRG-QC Quick Charger (sold separately) or the
24VCHRG-DPC Dual Port Charger (sold separately)
(Figs. 2 – 3).
Fig. 2
Battery pack
Charging
red
24VCHRG-QC
quick charger
(Sold separately)
Fully
Charged
green
+ Sun Joe charger
® ®
Fig. 3
Charging
red
Fully
Charged
green
24VCHRG-DPC dual port charger
(Sold separately)
3. The battery indicator LEDs will illuminate one by one
during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
4. The 24VCHRG-QC Quick Charger (sold separately) and
the 24VCHRG-DPC Dual Port Charger (sold separately)
are also equipped with additional charging indicating
lights which will indicate the charging status (Figs. 2 – 3).
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
This charger does not automatically
turn off when the battery is fully charged. Please take care
not to leave the battery plugged into the charger. Switch
off or unplug the charger at the mains when charging is
complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock buttons and sliding the
battery backward to unlock it from the charger.
Assembly
m
WARNING!
Unpacking and assembly should be
completed on a flat and stable surface, with adequate space
for moving the machine and its packaging.
m
DANGER!
Never start the motor before installing the
guide bar, chain, and chain/sprocket end cover. Without all
these parts in place, the clutch can fly off or explode, exposing
the user to potentially serious injuries.
10
Battery pack