sunjoe 4V-PS10-CT Manual De Operación página 17

Fig. 24 Properly Adjusted Warm Chain
Flats are not
visible here
Approximately 0.050 in. (1.25 mm)
Chain Needs Tensioning
Flats are
visible here
NOTE: A new chain tends to stretch. Check the chain tension
frequently and re-tension as needed.
Nuts and Screws
Periodically check that all the nuts and screws are tightened
securely. Check that the cam-locks and assembly locks are
intact and in proper working order.
Chain Sharpening
m
WARNING!
To ensure that the saw works safely and
efficiently, it is essential that the cutting components are
well-sharpened. It is highly recommended to replace the
chain once it loses its ability to cut cleanly and safely.
It is possible, however, to sharpen the existing chain if the
sharpening is carefully performed. Any work on the chain
and bar requires specific experience and special tools. For
safety purposes, we recommend you contact an authorized
Snow Joe + Sun Joe dealer or call the Snow Joe
® ®
Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563).
Sharpening is necessary when:
• The sawdust looks like dust;
• Cutting becomes more difficult;
• The cut is not straight;
• Vibrations increase.
An authorized service center will sharpen the chain using the
right tools to ensure minimum removal of material and even
sharpness on all the cutting edges.
If you sharpen the chain by yourself, it's recommended to
purchase Sun Joe 24V-CSSHRP-LTE chain saw sharpener,
®
which can be powered by the same 24V iON+ battery with this
cordless pole saw. Visit sunjoe.com or call the Snow Joe
Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) to order.
Otherwise, use special round-section files with the right
diameter depending on the type of chain (see "Chain
Maintenance Table" on pg. 21). You need a certain amount of
skill and experience to avoid damaging the cutting edges.
Sharpen the chain as follows (Fig. 25):
• Secure the bar firmly, with the chain mounted, in a
suitable vise.
• Tighten the chain if it is loose.
• Mount the file in the guide and then insert it in the tooth at
a constant angle from the cutting edge.
• Sharpen in a forward motion a few times and repeat this
on all the cutting edges facing the same way (right or left).
• To move the chain forward, use a screwdriver.
• Turn the bar over in the vise and repeat on all the other
cutting edges.
• Check that the depth limiter tooth does not stick out
farther than the inspection tool and file any projecting
parts with a flat file, rounding off the edges (Fig. 25).
• After sharpening, remove all traces of filing and dust
and lubricate the chain in an oil bath. Replace the chain
whenever:
– The length of the cutting edges decreases to 5 mm
or less;
– There is too much play between the links and the rivets.
Fig. 25
+
®
Cutting edge
+
®
17
Inspection tool
Depth
limiter
tooth
Depth limiter tooth