Cardin ZVL614.00 Serie Manual De Instrucciones página 13

Status led 'L1' on the receiver:
flashing rapidly: cancelling a single user; flashing slowly: memorising a single user;
continuously lit: memory full
Functions
Attention! Before memorising the transmitters for the first time remember to cancel the entire memory
content.
Memorising a channel (fig. 5a, 6, 7, 8, 9)
1. Keep button 'P1' MEMO pressed down and the led 'L1' will start to flash slowly
2. Press the channel on the transmitter which is to be memorised.
3. Keep button 'P1' pressed down and wait until led 'L1' starts to flash again.
4. Press the channel on the transmitter which is to be memorised again (same transmitter, same channel.
If the channel or the transmitter is different you will not be able to memorise the channel.
5. End of the memory procedure. Led 'L1' will remain lit for 2 seconds meaning that the channel has been
correctly memorised. Release button 'P1'
• It is not possible to memorise a user code that is already in memory: In this case when the transmitter is
activated (point 2) the led will stop flashing. The program will only work again when button 'P1' MEMO
has been released.
• If the transmitter is not activated a second time within fifteen seconds the program will automatically
leave the memory mode without memorising a new user code.
• If a new user code is activated the first time and a different channel (with an already memorised user
code) is activated the second time, the program will automatically leave the memory mode (because
the two codes do not correspond) and the channel present in the second transmission will be activated.
When the receiver's memory is almost full the user search function can take up to 1 second to complete.
Cancelling a channel (fig. 5a, 6, 7, 8, 9 )
1. Keep button 'P2' DELETE pressed down and the led 'L1' will start to flash rapidly
2. Press the channel on the transmitter which is to be cancelled
3. Led 'L1' will remain lit for 2 seconds meaning that the channel has been cancelled.
13