Cardin ZVL614.00 Serie Manual De Instrucciones página 14

Note: If the user which is to be cancelled is not found in the memory, the led will stop flashing. The program
will only work again when button 'P2' has been released. If the button is released before a channel is
activated the program will automatically leave the memorising or cancelling mode.
Cancelling the entire user memory (fig. 6, 7, 8, 9)
1. Keep buttons (P1+P2) pressed down simultaneously for more than 4 seconds
2. Led 'L1' will remain lit for the period of time required for the program to cancel all the codes (about 8
seconds)
3. Led 'L1' will turn off meaning that the cancellation procedure has been carried out.
Memorising a channel (fig. 5)
• Memorisation can be activated by radio (without opening the receiver container) if jumper 'J3' has
been inserted (fig. 6, 7, 8).
1. Make sure that the jumper 'J3' has been inserted in receiver.
2. Using a transmitter, in which at least one channel button 'A,B,C or D' has already been memorised in
the receiver, press the button 'MR' as shown in figure '5'.
Note: all the receivers within range when the channel button is pressed (and which have at least one
of the transmitter channel buttons memorised) will activate their signal buzzer 'B1' (fig. 6, 7, 8, 9).
3. Press one of the channel buttons on the transmitter. The receivers which do not contain that channel
code will sound a five-second long 'beep' and will then deactivate. The receivers which contain the
channel code will sound a one-second long 'beep' and will enter the programming mode.
4. Press one of the channel buttons on the transmitter which you wish to memorise; the receiver will
sound 2 'beeps' of half a second each after which the receiver will be ready to receive another code.
5. To leave the programming mode wait for 5 seconds without pressing any buttons. The receiver will
sound a five-second long 'beep' and will then exit the programming mode.
• When the memory is entirely occupied the buzzer will sound 10 rapid 'beeps' and will automatically
leave the 'programming via radio' mode.
Led 'L1' will remain lit on the receiver. The same signal is given each time you try to enter 'programming
via radio' when the memory is full.
14