English
Installing the aquarium filter and aquarium heater
DANGER! Personal injury or material damage.
▶ Heed the operating manual for the aquarium filter and the aquarium heater, especially the chapters
on safety, commissioning and operation.
7.
Operation
Filling the aquarium
CAUTION! Material damage.
▶ Do not use hard objects or cleaning agents for cleaning.
1. Before filling, thoroughly clean the aquarium with warm water and a soft, clean sponge.
2. Decorate the aquarium with gravel, stones, plants, etc.
DANGER! Electrocution due to penetrating water!
The LED light is only protected against penetrating water if immersed temporarily.
▶ The distance from the underside of the light d to the highest water mark must be a minimum of
15 mm (⌦I).
3. Fill the aquarium with water to a maximum of 10 mm above the lower edge of the cover frame b
(⌦I).
Switching the LED on/off
1. Insert the mains plug in the mains socket.
Laying on the cover (⌦J/K)
The cover g is narrower in width than the cover h.
1. Lay the cover g in the lower sliding surface of the cover frame.
2. Lay the cover h in the upper sliding surface of the cover frame.
Opening/closing the cover
CAUTION! Material damage.
Condensation can form on the underside of the covers. When the cover is folded back, condensation
can collect in the cover frame and flow out through the rear openings.
▶ Only the covers by pushing them sideways or folding them back to the side.
8.
Maintenance
DANGER! Electrocution!
▶ All devices must be disconnected from the power supply before any maintenance work is carried
out.
16