Installation Requirements; Safety Check - Bodypoint SH235S Instrucciones De Instalación Y Para El Usuario

INSTALLATION
Seat user in wheelchair and establish correct posture
with pelvic support belt. Place harness on user with
upper straps between neck and shoulder joint.
Rear-pull
TOP STRAPS
1. Determine desired adjustment pull direction and attach top strap to harness.
2. Adjust each shoulder strap for a comfortable fit, according to the user's shoulder width and sitting position. Mark
backrest for mounting screws.
3. Attach to backrest using Bodypoint end-fittings and suitable fasteners.
LOWER STRAPS
Wrap lower straps around backrest without obstructing other devices on wheelchair. Mount end-fittings
between the lowest rib and the seat. Attach using suitable fasteners.

SAFETY CHECK

Have user lean forward and from side to side to check fit.
Check for:
1. Normal operation of buckles and adjustment straps
2. Comfort – If rubbing neck, relocate upper straps.
3. Position – If too high or too low adjust lower straps.
4. Interference with other devices – Relocate straps as nec-
essary to clear seat tilting mechanism, armrests, accessory
pads, or feeding tubes.
Front-pull

INSTALLATION REQUIREMENTS

1. Wheelchair with a solid backrest or strap guides
set approximately at shoulder height (adjust up/
down for pressure distribution).
2. Mounting screws with a minimum pullout strength
of 90kg (200lbs) (Not included in package).
en
Ø5-6mm
(3/16-1/4")
Cam Buckle
(optional)
Suitable
for users up
to75kg