SNOWJOE SUNJOE iON100V-16ST-CT Manual Del Usuario página 16

Replace the Spool Assembly
NOTE: The spool assembly may wear out over time with
extended use. Should you wish to replace the whole spool
assembly, the instructions are provided below. A replacement
spool assembly (model iON100V-STRS) is available on
snowjoe.com.
1. Stop the machine and remove the battery.
2. First, remove the spool from the trimmer hub, follow steps
1 and 2 from the section "Replacing the Cutting Line"
beginning on page 14.
3. Take the spring out of the spool assembly (Fig. 25).
4. Using the provided hex key, remove the hex nut used to
fix the trimmer hub (Fig. 29). Then the trimmer hub can be
removed easily. Retain the hex nut.
Fig. 29
Hex nut
Trimmer hub
5. To assemble the new spool assembly, first push both
releasing tabs to separate the trimmer hub from the
assembly (Fig. 30). Also remove the trimmer line from the
spool.
Fig. 30
Spool cover
Spool
Spring
6. Place the trimmer hub on top of the cutting head, fix with
the hex nut, and use the hex key to secure it in place
(Fig. 28).
Trimmer hub
16
7. Re-install the spool and wind the line as instructed in
steps 3 to 6 of "Replacing the Cutting Line".
IMPORTANT: Keep all areas of the cutting head and cutting
head cover clean. Replace the spool cover by pushing it firmly
onto the cutting head to lock in place. To ensure that the spool
cover is properly secured, try to remove it without depressing
the two releasing tabs. If it is correctly fitted, it should not
detach.
Storage
Follow these recommendations for storing the string trimmer.
• Clean the string trimmer thoroughly before storing.
• Store the string trimmer in a stable and safe position out of
the reach of children. Keep the trimmer in a dry place where
the temperature is not too hot or too cold.
• When storing the string trimmer, do not rest it against the
floor. Hang it by the upper handgrip so that the guard does
not touch anything. If the guard rests against a surface, its
shape and dimensions could be permanently altered, and
could render the machine unsafe to use.
Battery Caution + Disposal
Always dispose of your battery pack according to federal,
state, and local regulations. Contact a recycling agency in your
area for recycling locations.
m
CAUTION!
Even discharged battery packs contain
some energy. Before disposing, use electrical tape to cover
the terminals to prevent the battery pack from shorting, which
could cause a fire or explosion.
m
WARNING!
To reduce the risk of injury or explosion,
never burn or incinerate a battery pack even if it is damaged,
dead, or completely discharged. When burned, toxic fumes
and materials are emitted into the surrounding atmosphere.
1. Batteries vary according to device. Consult your manual
for specific information.
2. Install only new batteries of the same type in your product
(where applicable).
3. Failure to insert batteries in the correct polarity, as
indicated in the battery compartment or manual, may
shorten the life of the batteries or cause batteries to leak.
4. Do not mix old and new batteries.
5. Do not mix Alkaline, Standard (Carbon-Zinc), or
Rechargeable (Nickel Cadmium, Nickel Metal Hydride, or
Lithium-Ion) batteries.
6. Do not dispose of batteries in fire.
7. Batteries should be recycled or disposed of as per state
and local guidelines.