Worx LithiumDrive WU252 Manual Del Usuario página 7

SYMBOLS
Read the manual
Warning
Use inside only
No not expose to rain or water
Do not burn
Do not dispose of batteries, Return exhausted
batteries to your local collection or recycling
point
13L-WU252-M-070228-FÓïCE´¦ÐÞ¸Ä.indd 7
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
Recharging batteries
a) Charging the battery
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery is charged for the first time
and after prolonged storage, the battery will only
accept approximately 60% charge. However, after
several charge and discharge cycles the battery
will accept a 100% charge.
b) Important notes for charging the battery
The battery in your new Screwdriver is not charged
when it leaves the plant. Therefore it must be
charged for 5~7 hours before using the first time!
c) Charging (See Fig A)
Plug the charger plug into a suitable power outlet,
the indicator won't illuminate. Next place the
Note: Before using the tool, read the
instruction book carefully.
7
2007-3-5 15:55:12