Return To Cembre For Overhaul - Cembre B500 Manual De Uso Y Mantenimiento

All manuals and user guides at all-guides.com
4.4)
ERRORS: these appear during operation, combined with a beep and flashing LED
Worklights, to notify the operator of procedural or operational errors.
Message Error description

The pressure release button (5) was

ERROR

pressed before the control parameters
ERROR

were reached (Force/Pressure).

ERROR

ERROR


ERROR

Abnormal power consumption of the

motor for more than 3 seconds.


001

The tool stops.
001


001


001



002

001

Output voltage of the pressure trans-
002


002 mitter is out of the pre-set range.



002



003

 002
003

 Failure to reach the set pressure within
003



003
30 seconds of continuous operation of



004 the machine.

 003
004


004

Overcharging of the battery with

004

 protection tripping.
 004
The tool stops.

Error screens are displayed for about 30 seconds before being reset, but will display
repeatedly in the event of permanent anomalies.
5. CONNECTION TO COMPUTER
The memory card integrated in the tool records operating data from 200.000 cycles for
transfer via the USB cable supplied.
To view and manage this data, go to www.cembre.com and register in the dedicated area,
then download the free Cembre software CEM_SWBT01.
Keeping the Firmware of the tool updated, via free of charge download from here, will
optimise the tool's performance.

6. RETURN TO Cembre FOR OVERHAUL

In the case of a breakdown, contact your local Agent who will advise you on the problem
and give you the necessary instructions on how to dispatch the tool to our nearest service
Centre; if possible, attach a copy of the Cembre Test Certificate supplied with the tool
or, if no other references are available, indicate the approximate purchase date and the
tool serial number.
Solution
Repeat the work cycle and wait for the motor
to stop automatically.
Wait for the display to turn off (60 sec.) or
remove and re-insert the battery, then re-
start the tool.
If the error occurs frequently, contact
Cembre.
Repeat the work cycle; if the error occurs
frequently, contact Cembre.
Repeat the work cycle; if the error occurs
frequently, contact Cembre.
Wait for the display to turn off (60 sec.) or
remove and re-insert the battery, then re-
start the tool.
If the error occurs frequently, contact
Cembre.
12