ERMILA 1870 Li+ Instrucciones De Uso página 12

ENGLISH
· Recommendation: To assure the precision of the battery power indicator, the battery should
de
not be recharged until all segments of the battery power indicator have gone out during battery
operation.
en
· Once all segments of the battery power indicator have gone out, the appliance still has around
10% remaining capacity.
· It should take around 60 minutes hour for the appliance to charge to full capacity.
fr
· Once the battery is fully charged, a signal will sound.
it
Battery operation
· Switch on the appliance using the on/off switch (Fig. 2ⓐ) and, after use, switch it off
es
again (Fig. 2ⓑ).
· After the appliance has been switched off, the display goes out about 30 seconds later (power
pt
saving mode).
· When the battery is fully charged, the appliance can be used for up to 90 minutes without mains
connection.
nl
· When the speed of the battery audibly begins to slow down, the battery has a remaining capac-
ity of approx. 2 – 3 minutes. Charge the battery.
sv
· When the battery has fully run down, the appliance will switch itself off automatically.
· Note: In case of insufficient maintenance of the blade set, the operating time can be reduced
no
considerably.
fi
Cutting-length adjustment
The cutting length can be adjusted to between 0.7mm and 3mm (5 possible positions) using the
cutting-length adjustment integrated into the blade set (Fig. 4). To do this, set the adjustment lever
tr
to the desired position and let it snap into place.
pl
Cutting with the attachment comb
The appliance can also be operated with attachment combs. In order to achieve the indicated cut-
cs
ting length, the cutting length adjustment lever should be set to position 1 (Fig. 4). The following
attachment combs are included as standard: 3 mm, 6 mm, 9 mm and 12 mm, 18 mm and 25 mm
cutting lengths.
sk
Attaching/removing the attachment comb
hu
· Slide the attachment comb on to the blade set in the direction of the arrow until it reaches the
limit stop (Fig. 5ⓐ).
sl
· The attachment comb can be removed by pushing it in the direction of the arrow (Fig. 5ⓑ).
ro
Cleaning and care
· Do not immerse the appliance in water!
bg
· After each use, remove the attachment comb and use the cleaning brush to remove cut hairs
from the housing opening and from the blade set. To do this, remove the blade set (Fig. 6ⓐ)
and press the cleaning lever (Fig. 7). This allows the cut hairs that accumulate between the bot-
ru
tom blade and the top blade to be easily removed using the cleaning brush (EASY CLEANING).
· The charging contacts on the appliance and charging stand should always be kept clean.
uk
· Only wipe the appliance with a soft cloth, which may be dampened slightly. Do not use solvents
or abrasives!
el
· The blade set can be cleaned with hygienic spray, order no. 4005-7051.
· The 4in1 Blade Ice spray (order no. 2999-7900) delivers instant cooling, oiling and cleaning of
ar
the blade set, while also providing corrosion inhibiting action.
12