Maintenance / Service - Skil 2636l Manual Original

All manuals and user guides at all-guides.com
USE
• Charging battery 8
!
not develop its full capacity until
IMPORTANT:
- connect charger A with both wall
socket and contact B
- indicator C lights up GREEN indicating
that the battery is being charged
- during the charging procedure, the
handle of the tool warms up; this is
normal
- when the battery is fully charged,
approximately 3 hours)
- the lithium-ion battery can be charged
at any time (interrupting the charging
procedure does not damage the
battery)
- the lithium-ion battery does not have
to be empty before charging (no
cadmium batteries)
- the tool cannot be used during the
charging procedure; it is not defective
when inoperative during the charging
procedure
- if you anticipate long periods of non-
use for the tool, it is best to unplug the
charger from its power source
•
9
• Changing direction of rotation q
- when not properly set in left/right
position, switch D 2 cannot be
activated
- indicator F shows the selected
direction of rotation
!
standstill
• Changing bits w
- push bit to end position in bitholder G
!
• Automatic spindle-lock
Allows you to manually tighten or loosen
screws, when necessary e
• Spot light r
Spot light H automatically lights on when
activating switch D, even when switch E
is in the middle (locking) position
• Bit storage J 2
• Battery level indicator
When indicator C 2 lights up RED while
switch D 2 is depressed half way, then
the battery has less than 30% of its
capacity and should be charged
• Battery protection
1) the battery temperature gets too high
(> +65°C)
2) the lithium-ion battery is nearly empty
(to protect against deep discharge)
APPLICATION ADVICE
• Use the appropriate bits t
!
!
• When turning in a screw at/near the
cross cut end or an edge of wood, pre-
drill a hole in order to avoid cracking of
the wood
• For an optimal use of the tool a steady
pressure on the screw is required,
especially while removing
• When screwdriving in hard wood one
should pre-drill a hole
• For more tips see www.skil.com

MAINTENANCE / SERVICE

• This tool is not intended for professional
use
• Keep tool and charger clean
!
• If the tool/charger should fail despite the
care taken in manufacturing and testing
procedures, repair should be carried out
by an after-sales service centre for SKIL
power tools
13