Parameter Setting And Display; List Of Parameters - Sime BRAVA ONE HE 25 Manual De Instalación Y Mantenimiento

3.3

Parameter setting and display

To go into the parameter menu:
– from the selected mode (eg. WINTER)
– press the buttons < and o
same time until "tS" (installer) appears on the 2 digits of the
display which alternate with "0.1" (parameter number) and
a "2" (set value)
– press the button > to scroll up the list of parameters and
then < to scroll down the list
holding the buttons >
NB:
scrolling movement.
– once the required parameter has been reached, press the
button o to confirm and access the set value which will
then flash and can then be modified
3.4

List of parameters

Type No. Description
Index showing boiler power in kW
tS 0.1
1 = 25; 2 = 30
Hydraulic configuration
0 = rapid
tS 0.2 1 = hot water tank with thermostat
2 = hot water tank with sensor
3 = two programmer
Gas Type Configuration
tS 0.3
0 = G20; 1 = G31
Combustion configuration
tS 0.4 0 = sealed chamber with combustion control
1 = open chamber with smoke probe
tS 0.7 Ignition power
tS 0.8 External sensor value correction
72
All manuals and user guides at all-guides.com
(approximately 5 seconds) at the
or < increases the speed of the
CONFIGURATION
– to modify the value in the permitted range, press the but-
tons > to increase it or < to decrease it
– once the required value has been reached, press the button
o to confirm.
When all the parameter modifications have been made, exit
the parameter menu by pressing and holding down the but-
tons < and o at the same time
splayed.
Range
1 .. 2
0 .. 3
0 .. 1
0 .. 1
0 .. 40
-5 .. +5
EN
until the initial screen is di-
Unit of
measu- Step Default
rement
- 1 1 or 2
- 1 0
- 1 0
- 1 0
- 1 0
°C 1 0