Operating The Engine; Starting The Engine - GGP ITALY P680 Manual De Instrucciones

EN 8

5. Operating the Engine

WARNING!
!
It is very dangerous to run
a chainsaw that mounts broken parts or lacks
any parts. Before starting engine, make sure
that all the parts including bar and chain are
installed properly.

• STARTING THE ENGINE

1. Fill fuel and chain oil tanks respectively, and
tighten the caps securely.
2. Set the switch to "I" position.
3. While holding the throttle lever together with
the trigger safety, push in the side latch and
release the throttle lever to leave it at the
starting position.
4. Pull out the choke knob to the closed posi-
tion.
All manuals and user guides at all-guides.com
(1) Chain oil
(2) Fuel
(1) Switch
(1) Trigger safety
(2) Throttle lever
(3) Latch
(1) Choke knob
5. Operating the Engine
NOTE
When restarting immediately
after stopping the engine, leave the choke knob
at the open position.
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously.
WARNING!
!
Do not start the engine
while the chain saw hangs in one hand. The
saw chain may touch your body. This in very
dangerous.
6. When firing occur, push in the choke knob
and pull the starter again to start the engine.
7. Allow the engine to warm up with the throttle
lever pulled slightly.
WARNING!
!
Keep clear of the saw
chain as it will start rotating upon starting of
engine.
• CHECKING THE OIL SUPPLY
WARNING!
!
Make sure to set up the bar
and the chain when checking the oil supply.
If not, the rotating parts may be exposed. It is
very dangerous.
After starting the engine, run the chain at medi-
um speed and see if chain oil is scattered off as
shown in the figure.
The oil flow can be changed by turning the
adjuster knob on the top of the cylinder cover.
(1) Chain oil