GYS GYSMATIC TRUECOLOR GOGGLE 3 Manual De Usuario página 9

Translation of the original instructions
• «Shade» buttons : Setting of the shade :
- «A/M» : Short Press-In the welding mode switch automatic or manual setting the shade number. Long Press-Test Function: Screen Flashes—
Grind—Cut—Weld.
AUTO/MANUAL indicates the current shade number setting mode. In the manual mode (MANUAL), the screen will show current setting shade
SHADE
number. In the automatic mode (AUTO), the button («-» and «+») can adjust the automatic shade number from -2 to+2.
4
- «-» : Short Press : Decrease the shade number. Long Press : In the welding and automatic shade number mode, main window quickly
decreases the shade number.
- «+» : Short Press : Increase the shade number. Long Press : In the welding and automatic shade number mode, main window quickly
increases the shade number.
• «Left» button : Setting the left window.
L
Short Press : Setting the left window and press the button once to increase the sensitivity. Long Press : Quickly back to the main window
5
parameter display screen.
• «Right» button : Setting the right window.
R
Short Press : Setting the right window and press the button once to increase the sensitivity. Long Press : Quickly back to the main window
6
parameter display screen.
PRECAUTIONS
• The welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas.
• Standard protective screens must be installed on both inside and outside surfaces of the module. Failure to use protective screens may constitute a safety hazard or result
in irreparable damage to the module.
HEADBAND ADJUSTMENT
2
4
MAINTENANCE
• Expiration date: No expiration date for this product but the state of the GYSMATIC LCD GOGGLE 3 welding helmet must be checked before each use.
• The GYSMATIC LCD GOGGLE 3 must not be dropped
The deterioration of the optoelectronic filter or its protective screen can reduce the vision field or the protection level. Replace the damaged parts.
• Do not use any tools or other sharp objects to remove any components of filter or helmet. Doing so may damage filter or helmet, preventing proper function, possibly
causing injury or cancellation of the warranty.
• Clean and change protective screens on a regular basis.
REPLACING SCREEN AND LENS
GYSMATIC TRUECOLOR GOGGLE 3
Clear shade 3
Dark shade (main window) Cut : 4-8 / Weld : 8-13
Dark shade (side windows) 10
Filter dimension 110x90x8.5 mm
Reaction speed 0.1 ms
Power supply Solar + battery
Weight 573 gr
Field of vision 130.8x58.5 mm
Applications MMA / TIG>2A / MIG / Grind
Warranty
2 years
Application temperature -5°C / + 55°C
Storage temperature -10°C / + 60°C
1
3
The Ergolift+ headband is lightweight and ergonomic. Its 3 points adjustable
balance design provides more flexibility and comfort.
1- Headband adjustment
2- Headband slider(with 3 slots)
3- Block washer adjustment
4- Longitudinal adjustment
9
1. Unlock the snap joint of protection plate if it is locked (A).
Press the snap joint for protection plate and then take out
the plate (A).
2. Change another protection plate and insert the snap joint
(make sure "a" side close to the helmet) and then lock it (B).
3. Insert a finger into the semicircular hole and pull out the
inner protection lens (C). Remove protection film from
lens. Place inside protection lens (C) back into the front of the
helmet by inserting one side of the lens into either side
slot and then bend the lens just enough that it will slip into
the other side slot.
EN