General Operation; Listening To The Radio - AEG SR 4364 BT Instrucciones De Servicio

For wireless operation from a distance of up to 5 meters. Dur-
ing operation, please ensure a clear line of view between the
remote control and the sensor (IR) on the device. If this range
should diminish, the battery must be replaced. Replace the
battery as follows:
1. Open the battery compartment.
2. Replace the cell with a battery of the same type
(CR 2025). Please observe the correct polarity.
3. Close the battery compartment.
WARNING:
• Do not expose the batteries to intense heat such as
sunlight, fire or similar. There is a risk of explosion!
• Keep batteries away from children! They are not a toy.
• Do not open batteries with force.
• Avoid contact with metallic objects (rings, nails, screws,
etc.). There is a risk of short circuit!
• Batteries may heat up considerably through a short
circuit or may even ignite. It could result in burns.
• The battery terminals should be covered with adhesive
tape during transport for your safety.
• Batteries can leak out and can lose battery acid. If the
device is not used for a longer period of time, remove
the battery from the remote control.
• If a battery does leak out, do not rub the liquid into your
eyes or the mucous membranes. In case of contact,
wash your hands, rinse your eyes with clear water, and if
the symptoms persist, consult a doctor.
CAUTION:
• Batteries can leak out and can lose battery acid. If the
device is not used for a longer period of time, remove
the battery from the remote control.
• Batteries do not belong in the household waste. Please
dispose of spent batteries at authorized collection
points or at the dealer.
Transport Safety Device, CD Compartment
• Open the CD tray (4) by pressing the PUSH TO OPEN
button (5).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.

General operation

NOTE:
• You will find some buttons both on the device and the
remote control. Identical buttons have the same func-
tion.
• The operation of the device is described by the buttons
on the device.
Turning device on/ off
• Press the /FUNC button (20) to turn the device on.
• In order to switch off the unit, keep the /FUNC button
pressed for approx. 2 seconds. The control lamp PAIR/
STANDBY lights up red.
NOTE:
After about 15 minute without a signal, the device will
automatically switch to standby.
Volume
You can adjust the desired volume with the
(3/18).
/FUNC (20)
Press the /FUNC button until the desired operating mode
is shown in the display.
EQ (7)
Press the EQ button repeatedly to select one of the preset
equalizer sound modes. You may choose from the following:
(FLAT, CLASSIC, ROCK, POP, JAZZ, DBBS).
Headphone jack (10)
For headphone operation, use headphones with a 3.5 mm
jack plug that you plug into the headphone jack of the
device. The loudspeakers will be shut off.
MUTE (15 on the remote control)
You can quickly shut off the sound using the MUTE button.
The notification "MUTE" will blink in the display. Press the
button again to turn the sound back on.

Listening to the Radio

1. Select the radio mode with the /FUNC button (20). The
display will show "FM".
2. Fully extend the telescopic antenna. Adjust its direction
for better reception.
3. You have two possibilities to look for and store radio sta-
tions.
• Automatic station scan:
Important! Any previously stored radio stations will
be overwritten.
Keep the / M+ / button (8) pressed for approx.
2 seconds. The device is searching the complete FM
frequency band for radio stations. The stations found
are stored ascending by frequency.
• Searching for radio stations manually:
Tune the required station with the /TUN+ or the /
TUN- button. If you keep one of the buttons pressed,
the unit will search for the next or previous radio sta-
tion.
English
47
/ buttons