Power Supply - Bresser MyTime Travel Instrucciones De Uso

Remote sensor (Fig. 4)
(10) Outdoor temperature and humidity
(11) Battery compartment
(12) CH button – Channel is to be selected at
channel 1.
(13) Wall mount hole – This hole makes it possible to
mount the remote sensor on a wall.
(14) °C/°F button – This button selects between
Celsius (°C) and Fahrenheit (°F).
(15) Table stand – Foldable. Use this stand to place
the device on a flat surface
BEFORE YOU START
IMPORTANT!
1. Insert batteries for remote units before doing so for
the main unit.
2. Place the main unit as close as possible to the
remote unit.
3. Position the remote unit and main unit within the
effective transmission range.
When changing batteries always change batteries in
the main unit as well as all remote units and replace
them in the correct order, so the remote connection
16
All manuals and user guides at all-guides.com
can be re-established. If batteries are exchanged in
only one of the devices (i.e. the remote sensor) the
signal can't be received or can't be received correctly.
Note, that the effective range is vastly affected by
building materials and position of the main and remote
units. Due to external influences (various RC devices
and other sources of interference), the maximum
distance can be greatly reduced. In such cases we
suggest to position the main unit and the remote sensor
at other places. Sometimes all it takes is a relocation of
one of these components of a few inches!
Though the remote unit is weather proof, it should be
placed away from direct sunlight, rain or snow.

POWER SUPPLY

Remote sensor
1. Open the battery compartment door.
2. Install 2 batteries (AAA size 1.5V) strictly according
3. Press CH button to select the channel.
4. Reinsert the battery compartment door.
Main unit
1. Open the battery compartment door.
to the polarities shown.