DURABLE 5089 Traducción Del Manual Original página 30

EN
English
▶ see figure 4 for # 5089
▶ see figure 15 for # 5090
– Drill 4 holes in accordance with the drilling plan.
– Insert the dowel (12).
– Screw the bracket in with the 4 screws (13).
Mounting the cover plate
▶ see figure 5 for # 5089
▶ see figure 16 for # 5090
– Place the cover plate (6) in front of the bracket from above.
– Press the plate backwards.
• The plate will lock in.
Monitor mount
▶ see figure 6 for # 5089
▶ see figure 17 for # 5090
– Lay the monitor on a flat surface with the display facing down-
wards. Place a cover or similar under it for protection.
– Remove any coverings in the mount area of the VESA plate (1)
on the monitor. Consult the monitor manufacturer's operating
instructions.
– Fasten the VESA plate (1) to the monitor with the enclosed
screws (9). Make sure that the plate is properly located. The
clamps must show the upper edge of the monitor.
– Insert the enclosed covering cap (10).
▶ see figure 7 for # 5089
▶ see figure 18 for # 5090
– Insert the VESA plate (1) into the bracket (8). Make sure that the
plate locks in fully.
▶ see figure 8 for # 5089
▶ see figure 19 for # 5090
– Rotate the monitor to the desired position.
▶ see figure 9 for # 5089
▶ see figure 20 for # 5090
– Insert the cable into the monitor.
30