DURABLE 5083 Traducción Del Manual Original página 24

EN
English
– Feed the clamping screw (8) through the pressure plate (7) into
the table mount (5) and secure it with the enclosed allen key.
Monitor mount
▶ see figure 6
– Lay the monitor on a flat surface with the display facing down-
wards. Place a cover or similar under it for protection.
– Remove any coverings in the mount area of the VES plate on
the monitor. Consult the monitor manufacturer's operating in-
structions.
– Fasten the VESA plate (1) to the monitor with the enclosed
screws (9). Make sure that the plate is properly located. The
clamps must show the upper edge of the monitor.
– Insert the enclosed covering cap (10).
▶ see figure 7
– Insert the VESA plate (1) into the bracket (11). Make sure that
the plate locks in fully.
▶ see figure 8
– Rotate the monitor to the desired position.
▶ see figure 9
– Insert the cable into the monitor.
– Insert the cable into the enclosed cable clamps (12) as shown.
– Secure the cable clamps (12) on the swivel arm as shown.
Operation
– Place the monitor in the desired position.
Swivel area
▶ see figure 10
WARNING!
Risk of product damage!
Do not move the swivel arm against the resistance in the
swivel joint.
24