Technical Data - AEG AL1218G Manual Original

TECHNICAL DATA

Battery Charger
Voltage range .........................................................................
Quick charge current NiCd .....................................................
Quick charge current Li-Ion ....................................................
Battery charging time NiCd (1.5 Ah) ...........................approx.
Battery charging time Li-Ion (1.5 Ah) ..........................approx.
Battery charging time Li-Ion (3.0 Ah) ..........................approx.
Weight according EPTA-Procedure 01/2003 ..........................
Recommended ambient charging temperature ......................
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and instructions
may result in electric shock, fi re and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS
Do not dispose of used battery packs in the household
refuse or by burning them. AEG Distributors off er to retrieve
old batteries to protect our environment.
Do not store the battery pack together with metal objects
(short circuit risk).
Use only System GBS chargers for charging System GBS
battery packs. Do not use battery packs from other systems.
The following battery packs can be charged with this
charger:
voltage battery rated No. of
capacity battery
cells
12 V B 12...R ≤ 1.5 Ah
14.4 V B 14...R ≤ 1.5 Ah
18 V B 18...R ≤ 2.0 Ah
12 V L 12...R ≤ 1.5 Ah
14.4 V L 14...R ≤ 2.0 Ah
14.4 V L 14...R ≤ 3.0 Ah 4x2
14.4 V L 14...R ≤ 4.0 Ah 4x2
18 V L 18...R ≤ 1.5 Ah
18 V L 18...R ≤ 2.0 Ah
18 V L 18...R ≤ 3.0 Ah 5x2
18 V L 18...R ≤ 4.0 Ah 5x2
12 V B1214G ≤ 1.4 Ah
14.4 V B1414G ≤ 1.4 Ah
18 V B1817G ≤ 1.7 Ah
18 V L18...R ≤ 2.5 Ah
18 V L18...R ≤ 5.0 Ah 5x2
18 V L18...R ≤ 6.0 Ah 5x2
Do not try to charge non-rechargeable batteries with this
charger.
No metal parts must be allowed to enter the battery section
of the charger (short circuit risk).
Never break open battery packs and chargers and store
only in dry rooms. Keep dry at all times.
Do not touch the tool with conducting objects.
Never charge a damaged battery pack. Replace by a new
one.
Before use check machine, cable, and plug for any
damages or material fatigue. Repairs should only be carried
out by authorised Service Agents.
This appliance is not intended to
be used or cleaned by persons
with reduced physical, sensory or
6 ENGLISH
All manuals and user guides at all-guides.com
................. 12-18 V
..................... 1,8 A
..................... 1,8 A
...................... 60 min
...................... 60 min
.................... 100 min 80%
.................... 550 g
............. +5...+40 °C
mental capabilities, or lack of
experience or knowledge, unless
they have been given instructions
concerning the safe use of the
appliance by a person legally
responsible for their safety. They
should be supervised whilst using
the appliance. Children shall not
use, clean or play with this
appliance, which when not in use
should be secured out of their
reach.
Warning! To reduce the risk of fi re, personal injury, and
10
product damage due to a short circuit, never immerse your
12
tool, battery pack or charger in fl uid or al-low a fl uid to fl ow
15
inside them. Corrosive or conductive fl uids, such as
3
seawater, certain industrial chemicals, and bleach or bleach
4
containing products, etc., Can cause a short circuit.
SPECIFIED CONDITIONS OF USE
5
The quick charger can charge AEG System GBS batteries
5
from 12 V to 18 V.
Do not use this product in any other way as stated for
normal use.
10
12
MAINS CONNECTION
15
Connect only to single-phase a.c. current and only to the
5
system voltage indicated on the rating plate. It is also
possible to connect to sockets without an earthing contact
as the design conforms to safety class II.
BATTERIES
New battery packs reach full capacity after 4 - 5 chargings
and dischargings. Battery packs which have not been used
for some time should be recharged before use.
CHARACTERISTICS
After inserting the battery into the reception of the charger
the battery will automatically be charged (red lamp is
illuminated continuously, green lamp is fl ashing)
When a hot or cold battery pack is inserted into the charger
(fl ashing red lamp), charging will begin automatically once
the battery reaches the correct charging temperature
(0°C...50°C).
Charging time varies depending on the battery temperature,
charge needed and the type of battery pack being charged.
As soon as charging is completed, the charger switches
over to "trickle" charge to maintain the full capacity (green
control lamp is illuminated continuously, red lamp off )
If both LEDs fl ash at the same time, either the battery has
not been completely mounted or there is a fault in the
battery or the charger. For safety reasons you must stop
using the charger and battery immediately and have them
inspected by an AEG Customer Service Centre.
Transporting Lithium Batteries
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in
accordance with local, national and international provisions
and regulations.
• The user can transport the batteries by road without
further requirements.
• Commercial transport of Lithium-Ion batteries by third
parties is subject to Dangerous Goods regulations.
Transport preparation and transport are exclusively to be
carried out by appropriately trained persons and the
process has to be accompanied by corresponding experts.
When transporting batteries:
• Ensure that battery contact terminals are protected and
insulated to prevent short circuit.
• Ensure that battery pack is secured against movement
within packaging.
• Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
MAINTENANCE
If the supply cord of this appliance is damaged, it must only
be replaced by a repair shop appointed by the manufacturer,
because special purpose tools are required
Use only AEG accessories and AEG spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service agents
(see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the ten-digit No. as well as the machine type
printed on the label and order the drawing at your local
service agents or directly at: Techtronic Industries GmbH,
Max-Eyth-Straße 10, 71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before
starting the machine.
Do not burn used battery packs.
Never charge a damaged battery pack.
Replace with a new one.
Do not dispose electric tools, batteries/
rechargeable batteries together with household
waste material.
Electric tools and batteries that have reached the
end of their life must be collected separately and
returned to an environmentally compatible
recycling facility.
Check with your local authority or retailer for
recycling advice and collection point.
This tool is only suitable for indoor use. Never
expose tool to rain.
Class II tool.
Time-lag fuse 3.15 A
T3.15A
European Conformity Mark
National mark of conformity Ukraine
EurAsian Conformity Mark.
ENGLISH 7