Disposal; Manufacturer's Warranty - Hilti DD 350-CA Manual De Instrucciones

Fault
Excessive play in the drilling
system.
The motor cuts out.
en

9 Disposal

Most of the materials from which Hilti machines or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back old machines and appliances for recycling. Ask Hilti customer service or your Hilti representative for further
information.
For EC countries only
Disposal of electric appliances together with household waste is not permissible.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
Recommended pretreatment before disposal of drilling slurry
NOTE
The disposal of drilling slurry directly into rivers, lakes or the sewerage system without suitable pretreatment presents
environmental problems. Ask the local public authorities for information about current regulations.
1. Collect the drilling slurry (e.g. using a wet-type industrial vacuum cleaner)
2. Allow the drilling slurry to settle and dispose of the solid material at a construction waste disposal site (the
addition of a flocculent may accelerate the separation process).
3. The remaining water (alkaline, pH value > 7) must be neutralized by the addition of an acidic neutralizing agent or
diluted with a large volume of water before it is allowed to flow into the sewerage system.

10 Manufacturer's warranty

Please contact your local Hilti representative if you have
questions about the warranty conditions.
36
All manuals and user guides at all-guides.com
Possible cause
The chuck is fitted incorrectly.
Poor fastening to the working surface.
The electronics are defective.
The core is stuck in the core bit.
Interruption in the electric supply.
Remedy
Push the chuck in as far as it will
go and then tighten the hex. socket
screw to a torque of 35 Nm.
Check the fastening and adjustment
of the leveling screws.
The machine should be repaired by
Hilti Service.
Remove the core.
Check the supply cord, extension
cord, supply cord plug, PRCD and
have them replaced by a qualified
electrician if necessary.