ClassicFlame 18E01 Manual Del Usuario página 4

POSITIONING/LOCATING YOUR
CLASSICFLAME™ ELECTRIC
FIREPLACE
When choosing a location for your new fireplace,
ensure that the general instructions are followed.
Also, for best effect install the fireplace out of direct
sunlight.
Cold climate installation
recommendation: When installing this
unit against a non-insulated exterior
wall or chase, it is mandatory that the
outer walls be insulated to conform to
applicable insulation codes.
E L E C T R I C A L C O N N E C T I O N
A 15 AMP, 120 Volt, 60 Hz circuit with a properly
grounded outlet is required. Preferably, the fireplace
will be on a dedicated circuit as other appliances on
the same circuit may cause the circuit breaker to trip
or the fuse to blow when the heater is in operation.
The unit comes standard with 6' (1828 mm) three wire
cord, exciting from the rear of the fireplace. Plan the
installation to avoid the use of an extension cord. If an
extension cord must be used, it must be a minimum
14 AWG, three wire with grounding type plug connec-
tor and rated not less than 1875 Watts. The cord shall
not be more than 20 feet in length.
WARNING: Electrical outlet wiring
must comply with local building codes
and other applicable regulations to
reduce the risk of fire, electrical shock
and injury to persons.
WARNING: Do not use this fireplace if
any part of it has been under water.
Immediately call a qualified service tech-
nician to inspect the fireplace and replace
any part of the electrical system.
Warning: Disconnect power before
attempting any maintenance or clean-
ing to reduce the risk of fire, electrical
shock or personal injury.
All manuals and user guides at all-guides.com
Keep electrical cords, drapery, furniture and other
combustibles at least 3 feet(0.9M) from the front of
the heater and away from the sides.
Clean the metal trim using a soft cloth, slightly
dampened with a citrus oil based product and buff
with a clean soft cloth. DO NOT use brass polish or
household cleaners as these products will damage the
metal trim. Citrus oil based products can be obtained
at supermarkets or hardware stores.
M A I N T E N A N C E O F M O T O R S
The motors used on the fan and the flame generator
assembly are pre-lubricated for extended bearing life
and require no further lubrication. However, periodic
cleaning/vacuuming of the fan/heater unit is recom-
mended. The louvers/vent in the control door should
be cleaned periodically, both inside and out. When the
control door is in the open position the heater
grill/screen should be vacuumed. The area around the
controls should also be kept clean. Make sure the unit
is turned OFF and unplugged whenever you are clean-
ing the heater or fireplace.
If repairing or replacing any electrical component or
wiring, the original wire routing, color coding and
securing locations must be followed.
C L E A R A N C E T O
C O M B U S T I B L E S
ELECTRICAL SPECIFICATIONS
Voltage:
Total Amps:
Total Watts:
Heater Rating:
C L E A N I N G T R I M
WARNING: Make sure the power is
turned off before proceeding. Any elec-
trical repairs or rewiring of this unit
should be carried out by a licensed elec-
trician in accordance with national and
local codes.
120VAC, 60 Hz
12.0 Amps
1500 Watts
1350 Watts