Installing Or Removing Grass Shear Blades - Makita XMU02 Manual De Instrucciones

Tijeras inalámbricas para hierba
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Adjusting the shearing height
2
3
012527
Changing the position of holding the change lever allows
three-stepped setting for sheared grass height (10 mm,
20 mm, 30 mm).
To change setting, tilt the change lever for the base frame
position and with the change lever tilted move it up or
down along the tool surface until the protrusion on base
frame fits in one of the holes in the tool and release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing blade cover
CAUTION:
Be careful not to contact the shear blade when
installing or removing the blade cover. Contacting
the shear blade may cause personal injuries.
1
012526
012525
Slide the blade cover from the tool's side until the shear
blade completely hides itself and then push in it lightly
towards the tool from the front.
1. Change lever
1
2. Protrusion on
base frame
3. Base frame
1. Shear blades
2. Blade cover
3. Blade frame
3
2
To remove the blade cover, take the above installation
procedure in reverse.
Installing or removing base frame
CAUTION:
Before installing or removing base frame, be sure
to install the blade cover.
When installing or removing base frame, take care
that your fingers are not be pinched between the
tool and base frame.
1
012528
To remove the base frame, upset the tool and take it out
of the groove grabbing its bottom.
1
2
3
012529
To install the base frame, fit the protrusion of base frame
near the change lever into the hole for the sheared grass
height setting. With the base frame so fitted, pull the
lower part of base frame and fit the other part of the base
frame in the groove in the tool.

Installing or removing grass shear blades

CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before installing or
removing shear blades. Failure to switch off and
remove the battery cartridge from the tool may
result in serious injury from accidental start-up.
When replacing the shear blade, always wear
gloves without removing blade cover so that hands
and face does not directly contact the blade. Failure
to do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
blades refer to the reverse of a package for
6
1. Groove
2
2. Base frame
1. Change lever
2. Protrusion on
base frame
3. Base frame

Publicidad

Tabla de contenido
loading

Tabla de contenido