Tabla de contenido
Publicidad
The battery is not fully charged in factory, please charge before using it.
charge and discharge the battery for two or three times, the battery capacity will reach the best condition. When the battery capacity is low,
please charge or change the battery.
The battery lasts shortly even if it is fully charged, the battery is depleted, please contact your local dealer to buy a new authentic battery.
INSTALLATION OF ACCESSORIES
Installation of Battery Pack
1)Align the two grooves of battery and the guide rail on the back of aluminum shell, ensure full contact and in parallel, then push the battery
up to the radio base along the rail on the back of aluminum shell, until the battery latch locks up. (picture 1)
2)To remove the battery, please make sure the radio is closed ,push the battery latch down, and make sure the radio and battery is on the
releasing state, and then push the battery out from the radio.(picture 2)
Picture 1
Installing and removing the antenna
1)Align the threaded end of antenna and the threaded hole at the top of radio, rotate the antenna clockwise until it is tight.(picture 3)
2)To remove the antenna, rotate it counter-clockwise until the antenna spirals out.(picture 4)
Installing Belt Clip
Align the two holds of belt clip and the two holes of the radios, fix them with the supplied M2.5x5 screws. loosen the screw set to remove belt
clip.(Picture 5)
Installing External Micro/Speaker
Open the cover of the Mic/speaker jack and insert the microphone/speaker plugs into the jack.(Picture7)
Picture 3
Picture 4
Picture 2
Picture 5
2
F
A/ B
1
2
Sca n
Pri
3
Vox
*
Loc k
4
5
Pow
6
SqI
0
Dw
Ani
7
8
Led
9
lig ht
#
Bee p
T-R
Picture 7
Publicidad
Tabla de contenido
