Publicidad
Idiomas disponibles
Idiomas disponibles
d.Check whether the shoe fixed firmly.
: For accurate cut it is necessary to make a trial cut, measure the
NOTE
work and reset the angle until the correct setting is achieved
Using Laser Button
WARNING
beam. Never aim the beam to any person or an
object other than the work piece.
Turn on: Press the laser button, the laser genera-
tor works.
Turn off: Release the switch again.
Adjusting the Cutting Action
This jig saw is equipped with four orbital ac-
tions. To adjust the cutting action, just turn the
cutting action changing lever to the desired cut-
ting action position. Refer to the table to select
the appropriate cutting action.
POSITION
0
I
II
III
CAUTION
or hardwoods should never be cut in orbital action. Failure to do so may cause
blade breakage, resulting in a serious injury.
Cutting Methods
: Do not stare directly at the laser
CUTTING ACTION
Straight line cutting action
Small orbit cutting action
Medium orbit cutting action
Large orbit cutting action
: Always hold the baseplate flush with the workpiece, and metal
Owner's Manual & Safety Instructions
APPLICATIONS
For cutting mild steel, stainless steel and
plastics.For clean cuts in wood and plywood.
For cutting mild steel, aluminum
and hard wood.
For cutting wood and plywood. For fast
cutting in aluminum and mild steel.
For fast cutting in wood and plywood.
JIG SAW
.07.
Publicidad
